Peco PL-82 Power Feed Joiners for C55, 80 Rail - 4 Pairs - Peco

Peco PL-82 Power Feed Joiners for C55, 80 Rail - 4 Pairs - Peco


In Stock | Only 23 left


£6.38
£7.50
Earn0
reward points


Delivery information
Rapid Dispatch

We use real time stock control, any item you add to your cart is in stock ready to be sent to you. 

Once your parcel is packed we will e-mail you to let you know it is on the way.

Fast Low Cost Shipping

FREE UK Special Delivery on all orders over £200.

Postage up to £4.50 maximum for orders under £200 in value (based on weight and dimensions).

All items are fully insured in transit.

We do not ship outside the UK.

Oh No! This product is out of stock. Would you like to know when it's avaliable again?

Send this to a friend

Peco PL-82 Power Feed Joiners for C55, 80 Rail - 4 Pairs


Product details

These new Power Feed Joiners will help address the worries of soldering that many modellers have; they're the safe, clean and tidy way of bringing power to the track. Supplied in packs of four pairs, each joiner has a short length of wire securely pre-soldered to it. The modeller just has to substitute the standard metal joiners for a pair of these where the power feed is required, and then pass the wires down through pre-drilled holes in the baseboard. With approximately 8 inches(204mm) of wire on each one there should be plenty of length available to go through most baseboards. In turn these wires can be connected to longer runs of wiring under the baseboard and be taken back to the outlet terminals of the transformer. Of course PECO can also supply the sire and cable connecting blocks to complete the set-up. These new Power Feed Joiners will also save time and help avoid accidental heat damage to the trackwork when using the soldering iron. They are sure to be popular with three types available. Suitable for N Scale Code 55& 80, OO-9/HO2.5 Code 80 rail profiles